PIC16C63A-20I/SS【PDF 15/184 页】IC MCU OTP 4KX14 PWM 28SSOP

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录3836

11页 12页 13页 14页 [15页]16页 17页 18页 19页

111

SAM7S Series [DATASHEET]

6175M–ATARM–26-Oct-12

Figure 19-6. Example of Partial Page Programming

The Partial Programming mode works only with 32-bit (or higher) boundaries. It cannot be used with boundaries

lower than 32 bits (8 or 16-bit for example).

After programming, the page (the whole lock region) can be locked to prevent miscellaneous write or erase

sequences. The lock bit can be automatically set after page programming using WPL.

Data to be written are stored in an internal latch buffer. The size of the latch buffer corresponds to the page size.

The latch buffer wraps around within the internal memory area address space and appears to be repeated by the

number of pages in it.

Note:

Writing of 8-bit and 16-bit data is not allowed and may lead to unpredictable data corruption.

Data are written to the latch buffer before the programming command is written to the Flash Command Register

MC_FCR. The sequence is as follows:

Write the full page, at any page address, within the internal memory area address space using only 32-bit

access.

Programming starts as soon as the page number and the programming command are written to the Flash

Command Register. The FRDY bit in the Flash Programming Status Register (MC_FSR) is automatically

cleared.

When programming is completed, the bit FRDY in the Flash Programming Status Register (MC_FSR) rises. If

an interrupt was enabled by setting the bit FRDY in MC_FMR, the interrupt line of the Memory Controller is

activated.

Two errors can be detected in the MC_FSR register after a programming sequence:

Programming Error: A bad keyword and/or an invalid command have been written in the MC_FCR register.

Lock Error: The page to be programmed belongs to a locked region. A command must be previously run to

unlock the corresponding region.

19.2.4.2

Erase All Command

The entire memory can be erased if the Erase All Command (EA) in the Flash Command Register MC_FCR is

written.

Erase All operation is allowed only if there are no lock bits set. Thus, if at least one lock region is locked, the bit

LOCKE in MC_FSR rises and the command is cancelled. If the bit LOCKE has been written at 1 in MC_FMR, the

interrupt line rises.

Erase All Flash

Programming of the second part of Page 7

Programming of the third part of Page 7

32 bits wide

16 words

...

Step 1.

Step 2.

Step 3.

...

(NEBP = 1)

16 words

Page 7 erased

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式